 "click for bigger photo")
 "click for bigger photo")
 "click for bigger photo")
 "click for bigger photo")
 "click for bigger photo")
 "click for bigger photo")
 "click for bigger photo")
My first car, back when I was in high school (1977), was a '64 LeMans. My second car was a '67 LeMans (I don't count the car I drove briefly inbetween these two - a '61 Comet!), so as you could imagine, I always yearned for the big brother of the LeMans - the GTO!
Years later my Dad got into old cars and bought a '51 Chevy, and started bugging me to buy a 60's era musclecar so I too could begin my second childhood. Time to buy a GTO! I started looking for the early body style of '64-'67, and was prepared to travel if needed. I looked online, found some nice possibilities, then got the idea to check the phone book. I called a few places, realized that it was a stupid idea (they're not sitting in the used-car lots), then got lucky and found this '66 nearby at Memory Lane Motors.
I bought it in August of 2000, just one week before I was to leave on a vacation to Lake Chelan in Eastern Washington. Of course I wanted to drive my new car. I did the usual things to get it ready: oil change, lube the front end, check the tire pressures, etc. The day before I was to leave I thought I'd adjust the clutch freeplay. When I took a look at the clutch fork push rod (photo), my heart sank. Where the hell am I going to find a replacement? I don't want to break down in the middle of nowhere! I called around, and the best I could find was Kirkland Pontiac, who said they could have the part in on Monday. Cool, but that would be too late. I kept calling, was about to give up, and then tried Evergreen Musclecar. They had the part in stock. Lake Chelan here we come!
A few years later my 389 was showing its age - burning oil, etc, so I decided to get it rebuilt. Because it's numbers-matching, I decided instead to pull it and buy a Pontiac 400 (much more plentiful) to rebuild. I found a 400 for $100 and took it to Dave Bisschop of SD Performance up in Canada. He's known as one of the top Pontiac engine builders in North America, so I knew I was in good hands. We decided to stroke the 400 out to 461 cubes and selected a solid lifter cam with duration of 256/262 at .050" lift. Dave ported my 6X heads to flow 240 CFM. The CR is a pump-gas friendly 9.5:1. The dyno rated this bad boy at 474 HP at 5500 RPM and 534 ft-lbs of torque at 4300 RPM.
Now that I could go, I needed to stop, so I installed a front disc brake conversion kit. While I was at it I replaced the ball joints, springs, bushings, tie-rod ends, center link, etc. The steering really tightened up as a result, and it was really nice to not have to plan in advance to stop.
To eliminate the maddening wheel-hop, I boxed the rear control arms and replaced the bushings. While I was at it I replaced the stock 10-bolt rear end with a 12-bolt built by Bill Scribner. It is slightly narrowed and running Moser axles and weld-on C-clip eliminators. I went with highway-friendly 3.31 gearing and love it. Not great at the track, but the drop in RPM on the highway is a relief!
){kind=link}
fjr340gts on Aug 8, 2008 said:
Now that's what I'm talkin' about!! Owning a super looking car, and NOT being afraid to take it out on the dragstrip!! That's great!!
[Reply to this comment]